Battery Status Indicator; Battery Runtime; Working With Plant Protection Products / Cleaning Agents (Accessory); Decommissioning And Storage - Gloria MultiJet 000300.0000 Mode D'emploi

MULTIJET.qxp_Text_GB 06.01.20 15:50 Seite 29
= Flat jet
= Sprinkler
= Turbo mill
= Needle jet
We recommend the following settings,
for example:
spray eco clean
Combine the set pressure with the "4 in 1
nozzle". We recommend the following
settings, for example:
spray eco clean
spray eco clean
ATTENTION
The high pressure can cause damage! If the
water pressure is too high, it can damage
the surfaces. Maintain a distance of at least
30 cm from painted surfaces. Do not clean
delicate surface with the turbo mill (e.g.
wood, tires, painted surfaces, etc.).
- Turn on the device with the 2-stage
16 17
On/Off switch (A) in the handle and
start with the cleaning.
Release the On/Off switch (A) if the work
18
is interrupted. The pump and water feed
are stopped. If there is a brief interrup-
tion, the device will start up again in the
last operating mode that had been
selected. If the interruption lasts longer
than 5 minutes, the device returns to the
"spray" operating mode. After another
5 minutes, the display turns off.
= plant protection products
set (accessory, not included
as standard)
+ = watering plants
+ = cleaning of larger
areas that are
moderately dirty
+ = cleaning of larger
areas that are very
dirty
+ = spot cleaning that
are very dirty

7.5.1 Battery status indicator

The device is equipped with a battery
charge indicator (J) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
Battery capacity:
batt.
batt.
Reserve ≤ 30%
Temperature protection / low voltage
cutoff:
batt.

7.5.2 Battery runtime

The battery runtime depends mainly on
the load of the device. Cleaning work in
"max." results in shorter battery runtimes.
Another factor is overly frequent starting
and stopping during cleaning, which can
also reduce battery operating time.
Handle the battery and the device as
described in the instructions.
7.6 Working with plant protection
products / cleaning agents (accessory)
GLORIA offers various accessories for the
MULTIJET for plant protection and more
intensive care. Information on these is
given in section 11 "Accessories / spare
parts".
8 Decommissioning & Storage
Figure 19

8.1 Decommissioning

Take the device out of operation by
releasing the On/Off switch (A) in the han-
dle.
CAUTION
19
RISK OF INJURY FROM RESIDUAL
PRESSURE IN THE WATER HOSE!
If you operate the device by supplying
the water from a mains water tap, there
is still pressure in the water hose after
the device has been switched off. For
that reason, only disconnect the hose
from the device once you have turned
29
batt.
batt.
≤ 60% 100%