Erase All; Power Supply - Profoon TX-230 Mode D'emploi

CALL BACK:
1. leave the handset on the cradle and use
the number to be dialed
2. as soon as the required number is on the display, lift the
handset and press
ERASE SPECIFIC NUMBERS:
1. leave the handset on the cradle and press
for the call to be deleted
2. press , the display shows "DEL?"
3. press again to erase the selected call or press
to the idle state

ERASE ALL:

1. leave the handset on the cradle and press
reading the memory
2. press and keep this button depressed until the display
shows "ALL DEL?"
3. press again to erase all calls or press
idle state

POWER SUPPLY:

Not installed or almost empty batteries are indicated by the flashing
batterysymbol on the display.
When batteries have been replaced, the display shows 12:00. Set
the time (DTMF system) or wait for a new call (FSK system).
After the battery replacing, the Caller-ID memory is empty. We
recommend to first read the memories prior to change the batte-
ries. The stored names and number will remain in memory. Even
during the replacing of the batteries.
Do not just throw away empty batteries but hand them
over to your local depot for chemical waste.
PABX:
In case your PABX is not capable to pass the Caller-ID signals,
than the TX-230 must be connected directly to the CO-line.
In case the TX-230 is connected through a PABX with prefix -0-,
then lift the handset, dial the -0- and than look for the number and
press button
; the number will be dialed
TIPS & REMARKS
.
31
and to look for
and to look
to return
and to start
to return to the