Hendi KITCHEN Série Mode D'emploi page 8

Technical data
Voltage
Frequency
Power
Capacity
Brewing time
Brewing temperature
Temperature after 6 hours on warming plate
Coffee filters
Measurements appliance
Glass decanter capacity
Possible problems and how to solve them
Problem
The On/OFF is pressed but it
does not light up.
The On/OFF is pressed and it
does light up but no function.
Appliance works, but water flow
is sometimes interrupted for
more than five minutes.
A fuse in the fuse box blows
when the appliance is turned
EN
on.
Empty the appliance (no water can remain in the appliance) before it is repaired. If in doubt, always contact
your supplier!
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose to
your waste equipment by handing it over to a des-
ignated collection point. Failure to follow this rule
may be penalized in accordance with applicable
regulations on waste disposal. The separate col-
lection and recycling of your waste equipment at
the time of disposal will help conserve natural re-
8
230 V
50-60 Hz
2100 W
maximum 100 cups / hour
1.8 litres / 5-8 minutes
93°~96°C
max. 80°C
Ø 25cm (90/250 mm)
195x370x(H)430mm
1.8 litres
Possible cause
1. Appliance is not plugged in
properly.
2. The On/OFF is broken.
1. Heating element is broken.
2. Temperature safety device is
damaged.
1. Relay is broken.
2. Temperature safety device is
damaged.
Short circuit.
when it was purchased and include proof of pur-
chase (e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
sources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off
your waste for recycling, please contact your local
waste collection company. The manufacturers and
importers do not take responsibility for recycling,
treatment and ecological disposal, either directly
or through a public system.
Solution
1. Insert plug into socket.
2. Contact your supplier for a
new switch.
Contact your supplier.
Contact your supplier.
Contact your supplier.