Hendi KITCHEN Série Mode D'emploi page 6

Brewing coffee
Note: To brew coffee with this appliance, a coffee
filter is required. Coffee filters Ø 25cm (x25, sup-
plied). Do not use this appliance without coffee fil-
ter in place.
To make coffee follow these steps:
1. Put the coffee filter (supplied) inside the filter
pan. Add the desired amount of ground coffee,
depending on your taste. The recommended
amount is 75-90 gm per pot of water (1.6-1.8
litre).
2. Place the filter pan in the holder.
3. Fill the coffee pot (glass decanter, vacuum pot
or thermos depending on model type) with the
desired amount of water and pour it in the water
reservoir. Then, close the lid of the water reser-
voir.
4. Place the empty glass decanter on the lower
warming plate.
5. Connect the power plug to a suitable electrical
power outlet.
6. Press the On/OFF button once to switch ON the
appliance and RED indicator lights up to indicate
that the brewing process has started.
EN
7. After some time coffee will start to drip into the
coffee pot.
8. When all of the water has passed through the
machine, red indicator light will switch off.
9. In order to keep warming of the glass decanter,
the appliance must remain switch ON.
Do not forget to turn the appliance off after use.
6
10. When served, remove the glass decanter from
the warming plate and pour the coffee careful-
ly to ensure that hot coffee is not spilled. Hold
the handle of the glass decanter only. Danger
of burns!
11. It takes about 5 to 6 minutes to brew one glass
decanter of coffee.
12. There is another warming plate at the top.
You can put the ready glass decanter on it &
press keep warming button to operate & keep
it warm. So that you can brew another glass
decanter of coffee at the same time using the
lower warming plate.
13. The appliance has an overflow tube to allow ex-
tra water in the reservoir to escape, but since
the coffee pot can hold only 1.8 litres of water
we recommend that you never fill the reservoir
with more than 1.8 litres of water.
14. Some water will always be left in the machine
and in the tubes. If you do not use or move the
appliance for a long time, it is best to empty the
appliance and clean it before storing it.
15. If you have emptied the appliance (as recom-
mended in no. 10 above), before using it again
you should repeat steps 1-7 of Preparing the
appliance for use.
16. If you haven't used the appliance for a short
time, rinse it out with clean water before use.