Hendi KITCHEN Série Mode D'emploi page 5

Grounding Installation
This appliance is classified as the protection class I
and must be connected to a protective ground.
Grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
Spare parts
1. Fill opening of water reservoir
2. Filter holder
3. Coffeepot
4. On/OFF button: Boiling the water & keep warm-
ing of lower warming plate
5. Keep warming button (Upper)
6. Warming plate
7. In-use indicator lamp
Preparation before first use
Remarks: With two glass decanter of 1,8 litre & 25
coffee filters included.
1. Check to make sure that all parts are undam-
aged. In case of any damage, contact your sup-
plier immediately and do NOT use the appliance.
2. Remove all the packing materials and protective
film (if applicable).
3. Place the coffee machine on a stable flat surface.
4. Put the filter in the holder.
5. Open the lid of the water reservoir. Fill the coffee
pot with cold water and pour it in the water res-
ervoir. Then, close the lid. Wait 1 minute for the
water to force the air out of the appliance.
6. Place the empty glass decanter on the lower
warming plate.
7. Connect the power plug to a suitable electrical
power outlet.
8. Press the On/OFF button once to switch ON the
appliance and RED indicator lights up to indicate
that the boiling process has started.
9. HOT WATER will soon start dripping into the pot.
10. When all of the water has passed through the
machine, red indicator light will switch off.
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly in-
stalled and grounded.
11. Press the On/OFF button to switch off the ap-
pliance.
12. Repeat steps 7 to 11 a few times to clean the
appliance thoroughly before making coffee for
the first time.
13. It is normal for steam to escape during this pro-
cess and for the dripping water to make gur-
gling sounds.
14. Let the appliance cool down for several min-
utes.
15. Remove the glass decanter from the warming
plate. Hold it only using the handle. Danger of
burns!
16. Discard the water from the first few boiling cy-
cles to remove any residues from the manufac-
turing process.
17. Clean the appliance afterwards,
Note:
1. Never pour hot water in the water reservoir.
2. Due to the manufacturing process, the appliance
may emit some odor when switched on first
time. this is normal and does not indicate any
defect or hazard.
EN
5