Adding Water - Keurig B60 Manuel D'utilisation

adding Water

The LCD Control Center of your Brewer will
8
fig.
indicate when the water level in the Water
Reservoir is low or if the Water Reservoir has
been removed by displaying the words "ADD
WATER" (fig. ). The blue light in the Water
NOT READY
Reservoir will also blink when water needs to
ADD
be added. The Brewer will not allow you to brew
WATER
when "ADD WATER" is displayed.
The Water Reservoir can be filled in two ways.
1. Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer,
then replace the Lid.
Remove the Water Reservoir from Brewer by first removing Lid from
2.
the Water Reservoir, then lifting the Water Reservoir straight up and
away from Brewer. Fill with water. Place the Water Reservoir back on
the Brewer and replace the Lid.
IMPORTANT: Do not remove the Water Reservoir during the
brewing process.
Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa from a packet,
for use in cooking, for making soups, etc. Simply raise and lower
the Handle on the Brewer without adding a K-Cup. The LCD Control Center
will display "READY TO BREW" and the Small Cup, Small Mug and Large
Mug Buttons will blink. Be sure to have a mug or cup on the Drip Tray Plate
and then select the size you would like.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water
brew cycle without a K-Cup.
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
If there is water in the Water Reservoir, remove the Lid, then lift the
1.
Water Reservoir straight up and away from Brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the Brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
Be sure the Brewer is turned on. Raise and lower the Handle on the
2.
Brewer without inserting a K-Cup.
The LCD Control Center will display "READY TO BREW" and the Small Cup,
3.
Small Mug and Large Mug Buttons will blink. Be sure to have a large mug
on the Drip Tray Plate and then select the Large Mug size brew.
Repeat steps 2 and  one more time to completely purge water from
4.
inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866.901.BREW (2739).
9