EUROM Q-time 2000 Manuel D'utilisation page 24

 By pressing one of the two operating switches (I pressed), you can set the patio
heater to half power (1000W). By pressing the other switch in too, you can also
switch the second light on and the device works at full power (2000W). Switch
off the lamps by pressing the switches again (O pressed).
 The patio heater does not have a thermostat and continues to give out heat until
it is switched off. Always keep a close eye on the patio heater when it is
switched on!
 Remove the plug from the socket when the patio heater is not in use.
Fall protection
The Q-time 2000S is equipped a fall safeguard. It will automatically switch off if,
despite the precautionary measures you have taken, the device falls over.
In this event, unplug the device immediately. Always check the patio heater
carefully for damage, then put it upright again. Never use a damaged device but
take it to your dealer or a recognised service point to be checked and/or repaired.
If you cannot find any damage, switch the patio heater off, insert the plug into the
socket and put the device on again. Monitor the patio heater closely for the first
fifteen minutes; if any defects occur, unplug immediately and take it to your
dealer/service point to be repaired.
Cleaning
Always switch the patio heater off, allow the patio heater to cool down and unplug
before cleaning. Clean using a damp cloth and, if necessary, a little cleaning fluid.
Never use corrosive or abrasive cleaning agents! After a while, dust and debris may
gather behind the grille (2). You can try to remove this carefully using a thin, soft
brush and a vacuum cleaner. Never use a compressor as this could damage the
lamps or the reflector. Avoid touching the lamps.
Removal
CE-declaration
See page 107.
In the EU this symbol indicates that this product may not be
disposed of as ordinary household waste. Old equipment contains
valuable materials, suitable for recycling. These materials should
be made suitable for reuse in order to prevent any adverse effects
to health and the environment caused by unregulated waste
collection. Therefore, please make sure that you bring old
equipment to a designated collection point. Alternatively, contact
the original supplier, who can make sure that as many of the
components as possible can be recycled.
24