EUROM Q-time 2000 Manuel D'utilisation page 22

Minimum distance top heater – fire-resistant ceiling: 0.3 metres
Minimum distance top heater – tent tarpaulin, parasol etc.: 0.3 metres
Minimum distance side heater – walls, obstacles, objects: 0.5 metres
If you suspend the device outside, ensure that it is protected from the wind.
Wall mounting
 The housing of the heater (1) must be at least 30 cm from the ceiling, 50 cm
from side-walls and 1.80 m above the floor.
 The patio heater must be affixed to a
sturdy wall made of stone or cement.
Never attach to walls made of wood
or other flammable material! Attach
using the bracket supplied; do not
use any other supports or
attachments!
 Drill four holes in the correct places
for the plugs and attach the wall
bracket to the wall using the screws.
The curved part of the plate must be
uppermost and the 'keyhole' must be
located at the bottom of the support.
The wall bracket must be horizontal.
 Attach the bracket (6) using the two
small screws on the patio heater, as
shown.
 Turn the hanging screw (7) into the corresponding hole on the side of the patio
heater, until it protrudes a maximum of 5 mm (see diagram).
 Hang the heater onto the wall support. The bracket at the back of the heater
unit must fall into the curved part of the wall support; the hanging screw (7)
must be placed into the round part of the 'keyhole' on the wall support and then
pushed gently downwards until the patio heater is firmly affixed. Secure this
with a bolt through both brackets (see diagram).
 Check that the patio heater is attached firmly and fully horizontally before use.
Assembling the stand (only S version)
 Place the bottom section of the stand (9, with
the fastening plate) on the base (8), in such a
way that the screw holes are aligned. Turn the
foot over and screw the lower section of the
stand from below with the plate and the locking
nut (see diagram). Turn the base the right way
up.Insert the 3 bolts through the double holes
and tighten them firmly. Place the protective
cover over the screw connection.
 Slide the adjustable, narrow section of the stand (12) from below through the
top section of the stand (11), until it comes out again at the top (widening at the
22