EUROM Q-time 2000 Manuel D'utilisation page 23

base). Secure the adjustable section using the black locking screw (15) that is
located at the top of the top section of the stand.
 Push the centre section of the stand (10) into the lower section (9), screw-hole
to screw-hole. Secure with four fixing screws. In the same way, secure the
upper section of the stand (11, with the adjustable part inside) over the central
section.
 Screw the extra black colored screw (supplied) into the
adjustable section of the stand so that it cannot, so
that it cannot slide into the upper section (to secure
the movable pipe).
 Then undo the hanging screw (7) almost entirely.
Place the top of the patio heater over the top of the
adjustable stand section so that the hanging screw
falls precisely into the recess on the stand. Now
tighten the screw firmly. The electrical cable can be
secured in the cable holders on the stand.
 Check that all connections are completely secure and that the terrace heater is
securely positioned before using it.
 The terrace heater must be placed at a distance of at least 1 metre from the
nearest wall. The box with the radiator lights must be at least 30 cm from a
ceiling and 1.80 metres above the ground. The terrace heater must be placed
firmly on an even and completely horizontal surface.
Stand Q-time 2000S
The stand that is supplied with the Q-time 2000S is
multifunctional. In the top of the narrow stand section, there is a
threaded section; a suitable screw with a black top is also
supplied. You can, therefore, also mount a lamp on the stand
(see diagram).
Patio heater functions
 The top of the patio heater can tilt to around
35°; set it to the position you prefer.
 The height of the heater top can be adjusted
with the S-system. The black locking screw (15)
on the upper stand section must be undone and
the adjustable stand section can be pushed
in/out of the upper section. Then tighten the
screw up firmly. The heater head must always
be kept at least 180 cm above the floor.
 Check that all of the safety requirements have
been fulfilled.
 Now insert the plug into the socket (220-
240V~50Hz).
23