Initial Operation; Before Starting; First Time Operation - UWE JETStream MIRO 1 Instructions De Montage Et Mode D'emploi

2

INITIAL OPERATION

2.1 Before starting

Safety precautions and operating instructions must be carefully read and observed before setting up and operating.

2.2. First time operation

Before operating, local safety requirements must be met and safety precautions must be observed.
Before operating the unit for the first time, rotate the pump by hand several times at the ventillating fan in
the direction shown.
Do not set a defective unit into operation.
Display the Safety Instructions in a clearly visible manner.
Keep the Operating Instructions available.
The water temperature must not exceed 35°C.
2.3 Installation Suggestion (fig 1)
Position the wall niches and ensuring that the read label "Oben" (top) is on top (fig 1)
For assembly of the unit MIRO 2, install the second MIRO wall fitting by keeping a lateral distance of 30 cm. MIRO 3 has to be
assembled centrically, 30 cm in below
direction , see picture 4. For assembly of MIRO 2 and MIRO 3, you need 2 intake screens. Please install them as shown in
picture 4. Place the wall fitting for the pneumatic switch at its required position. The wall fittings must be set flush with the
concrete pool wall.
In case of a liner / concrete pool, the wall niche may project in order to compensate for the cement render of liner insulation
thickness. It is advisable to make provision for protecting tube by placing in protective conduit or through adjacent cable /
ventilation ducts. Remove protective covers only before tiling.
• Tile plan (fig. 2 )
Render and tile to inner edge.
• Steel, aluminium and polyester pools
Install the seal, screws and clamping frame proceed as shown in fig. 3 and 4
• Install Pneumatic-Switch (fig 5)
14