Initial Operation - UWE JetStream VIVA Instructions De Montage Et Mode D'emploi

2

Initial Operation

2.1 Before starting
Safety precautions and operating instructions must be carefully read and observed before setting up and operating.
2.2. First time operation
Before operating, local safety requirements must be met and safety precautions must be observed.
Before operating the unit for the first time, rotate the pump by hand several times at the ventillating fan in the
direction shown.
Do not set a defective unit into operation.
Warning
Display the Safety Instructions in a clearly visible manner.
Keep the Operating Instructions available.
The water temperature must not exceed 35°C.
INSTALLING THE WALL NICHE IN CONCRETE SHUTTERED POOLS
• Installation (picture number 1 red bronze version)
Position first stage wall and wall components flush with structural concrete.
Remove protective covers only when ready to lay tiles / mosaics. In the case of a concrete/liner pool first stage components may
project in order to compensate for cement render or liner insulation thickness. Locate the pneumatic switch housing in a conveni-
ent position 15-20 cm below water level. It is advisable to make provision for protecting the pneumatic tube (PVC 2/4 dia.) and air
inlet tubes (PVC 12/21 dia.) by placing in protective conduit or through adjacent cable/ventilation ducts.
• Tile plan (picture number 2 and 3 red bronze version)
Render and tile to inner edge. Render & tile 6 cm max.
1
Concrete
24
Pneumatic
switch
housing
Shuttering
screws
M 6x35 if required
20
dimensions in cm
Shuttering
24
Sticker „top"
Wall fitting for
suction unit
2" PVC/ABS tube, elbow
Supplied by pool builder
Air net tube 8 m long
Instal floor fitting
flush with floor
Protective sleeve for
pneumatic tube Wall
thickness 24 -100 cm
approx 5-10 cm
above waterlevel
Ball
valve 2"
Stopper 2"
13
2
Render & tile
to inner edge
Render & tile
6 cm max.
3
6 cm