3 . Dry your nails in the base station air dryer. In order to do this, follow the steps below:
The air for the dryer is sucked in below the base station. To prevent dirt and scratches on
the nail polish, ensure that the base station is positioned on a clean surface.
4 . Connect the mains adapter with the base station and the socket.
5 . Press the dryer button on the base station.
6 . Keep your varnished fingernails in the dryer in the base station.
7 . To switch off the dryer again, press the dryer button on the base station
once more.
5. Cleaning
Warning
Before beginning cleaning, always pull the mains adapter out of the socket and disconnect it
from the manicure device!
• Clean the base station and the manicure device with a damp cloth. If they are very dirty, you
can also moisten the cloth with a mild soapy solution.
• For hygienic reasons, you may use alcohol and a cloth or brush to clean the attachments.
Allow the attachments to dry afterwards.
• Do not use any chemical or abrasive cleaning agents.
• Ensure that no water enters the device. If this should happen, reuse the device only when it
has fully dried out.
• Never submerge the base station, hand-held device or mains adapter in water or any other
fluids.
6. What if there are problems?
Problem
Manicure device
cannot be swit-
ched on.
7. Replacement parts and wearing parts
Replacement parts and wearing parts are available from the corresponding listed service ad-
dress under the stated material number.
Replacement part
Large sapphire wheel, fine
Large sapphire wheel, coarse
Small sapphire wheel, fine
Small sapphire wheel, coarse
Sapphire cone
Cylindrical cutter
Sapphire cutter, round
Possible cause
Mains adapter not connected to
the manicure device.
The manicure device is not char-
ged.
No voltage at the socket.
Material number
163.396
163.397
163.398
163.399
163.400
163.401
163.402
Solution
Insert the mains adapter into the so-
cket.
Charge the manicure device via the
base station or directly via the mains
adapter.
Check your fusebox.
21