Stadler Form EVA little Mode D'emploi page 14

sponge or brush. Use diluted descaling agent (mix according to the manu-
facturer's instructions) for lime deposits. Then rinse the water tray (5)
thoroughly with cold water and put the water tank, mist chamber (23) the
Water Cube back in.
• Descaling at least 1x per month. The appliance must be off for at least
15 minutes prior to internal cleaning! Then remove the water tank (2), the
mist chamber (15), the Water Cube (16) and the fragrance container (13). Fill
a cup with 200 ml of tap water mixed with descaling agent (mix according
to the manufacturer's instructions). Pour the liquid carefully into the water
tray (5) by holding the cup directly over the water tray (see page 5). Do not
pour the liquid into the water tray from high above the tray! Be sure that no
liquid enters the air outlet opening (18). This will damage the appliance and
will void any claim to the warranty.
• Let the descaling agent allow to take effect according to manufacturer's
instructions (approx. 30 min.). Check in the water tray (5) if the limescale
on the ultrasonic membrane (12) has dissolved.
• If limescale residue remains, the ultrasonic membrane (12) can be cleaned
with the help of the cleaning brush (17) (front- and backside). Do not try to
scrape them with a hard object.
• For stubborn limescale, we recommend descaling the appliance several
times in a row.
• Important: Pour the descaling agent out over the left front corner of the
appliance (see the arrow on the appliance). No water may enter the air
outlet opening (18). This will damage the appliance and will void any claim
to the warranty.
• To rinse, now fill the cup with 200 ml of tap water and carefully pour the
liquid into the water tray (5) by holding the cup directly over the water tray
(see page 5). Do not pour the liquid into the water tray from high above the
tray! Pour the water out over the left front corner of the appliance. Repeat
the process until there is no more descaling agent in the water tray (5).
Place the Water Cube (16), mist chamber (15), water tank (2) and fragrance
container (13) back into the appliance. If the water tank is not sitting right,
check if the upper part of the mist chamber (15) is properly mounted.
• Regularly as required: For external cleaning, rub with a damp cloth and
then dry thoroughly.
• At the end of the season: Before putting away the appliance at the
end of the season, decalcify as described above. Then clean it thoroughly
inside and out and let it dry completely. Insert a new Water Cube (16) in
order for your appliance to be ready for the start of the next season.
Replacement of the anticalc cartridge
• Please find the recommended replacement interval in the table (see «Be-
fore setup»).
• Tip: the efficiency of the cartridge (4) can be inspected with a simple test.
Hold a small mirror in the mist (19) for a few seconds. If white deposits (cal-
cium carbonate) appear on the mirror, then the cartridge needs changing.
• The anticalc cartridge is located on the inner side of the tank lid (3). First,
screw the tank lid (3) off the water tank (2) and then screw the cartridge
off the tank lid. Dispose of the cartridge in the domestic waste (4). Prior to
screwing the new anticalc cartridge into the inside of the tank lid, soak it
in water (not in the water tank!) for 24 hours.
• Keep the tank lid (3) when replacing the cartridge!