Setting Up / Operation - Stadler Form EVA little Mode D'emploi

3
4
With a water hardness above 21 °dH, we can no longer recommend the use of
an ultrasonic humidifier. We recommend that you use an evaporative humidi-
fier to increase the humidity in your house (e.g. an Oskar humidifier made by
Stadler Form: www.stadlerform.com/Oskar).
Note: Do not operate Eva little with decalcified water out of a decalcifica-
tion system that uses the principle of an ion exchanger (salt is added to the
water). The salt contained in the water may lead to white dust accumulation
around the appliance. To minimize this risk, you can operate Eva using a mix
of distilled and tap water.
However, Eva little may be operated from a drinking water filter system (e.g.
Brita). Should you be unsure about the quality or composition of the water in
your area, contact the caretaker or your drinking water provider.

Setting up / operation

1. Put Eva little in the desired location on a flat surface. Connect the power
adapter (1) to the unit and plug the adapter into a suitable plug socket.
2. Remove the water tank (2) by holding it by the handle and pulling it up.
Screw off the water tank lid (3) and fill the water tank with clean, cold tap
water up to the maximum mark. Make sure that the anticalc cartridge (4)
has been soaked in water for 24 hours prior (see «Before setup»). Finally,
screw the lid (3) back on the water tank (2). Then place the water tank
(2) in the unit. The water tray (5) will now slowly fill from the water tank.
Important: please do not move the appliance when it is filled with water.
The water could run into the electronics.
3. Press the on/off button (6) to switch Eva little on. The current relative hu-
midity in % is shown on the display (10). If the water level indicator light
(11) is red, there is too little water in the unit. The humidification output
level is pre-set to level 3 and the desired humidity at 45 %.
4. The desired humidity can be changed by pressing the hygrostat button
(7) several times (30 – 75 % and continuous operation «CO»). The symbol
on the display (10) blinks during input. After a few seconds without input,
the selected value is saved. The symbol changes to the current measured
humidity.
Info: Once the desired air humidity is reached, the appliance stops and
the display blinks. Should the measured current air humidity fall below
the set value, the appliance begins to humidify again.
5. The humidification performance can be changed by pressing the button
for the selection of the humidification output level (8) several times (lev-
els 1 – 5). The level is indicated on the display (10) by horizontal bars (e.g.
1 bar = level 1).
6. By pressing the auto button (9), the auto mode, and with it the Adaptive
Humidity Technology, is activated. Now the LED on the auto button on
TM
the unit is on. In auto mode, the unit adapts the humidification output
level automatically in order to reach and maintain the desired humidity
of 45 % quietly and in an energy-efficient way. The lower the current
humidity is, the higher the humidification output level will automatically
be set (under 33 % = level 4, from 34 % – 37 % = level 3, from 38 % – 41 %
Hard
From 14 °dH
Very hard
From 21 °dH
40 days approx. 120 L
20 days approx. 60 L