Cleaning And Storage - gourmetmaxx SM-1504 Mode D'emploi

Masquer les pouces Voir aussi pour SM-1504:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
The device is equipped with overload protection; the device switches off if it is
overloaded. In this case, pull the mains plug out of the plug socket and allow the
device to cool down for approx. 10 minutes. The device is then ready to be used
again.
1. Place the device with suffi cient clear space above it and on all sides on a dry, fl at and
solid surface. Be aware that there must be suffi cient clear space above to allow the
mixer head (12) to be fl ipped up.
2. Make sure that the suction cups (8) stick to the surface correctly.
3. Place the ingredients you want into the mixing bowl (10).
4. Insert the mixing bowl into the main device (7) and attach the attachment you want
(see "Attaching / Detaching Accessories").
5. The mains plug should be connected to a plug socket that has been properly installed.
The LED ring (2) fl ashes. The device is in standby mode.
6. Use the rotary switch (3) to set an appropriate speed level:
0
1 – 3
4 – 6
P
To activate pulse mode, the rotary switch must be held in the P position for the
length of time you want.
The mount (11) moves in a circular motion in the mixing bowl and the attachment
rotates around its own axis. The LED ring is lit up constantly while the device is
switched on.
7. To switch off the device, move the rotary switch to the 0 position. The LED ring
fl ashes. The device is in standby mode.
8. Remove the mains plug from the plug socket. The LED ring goes out.
CAUTION – Danger of injury due to rotating device parts! Always wait until
the attachment has come to a complete standstill before fl ipping up the mixer
head.
9. Remove the used attachment and the mixing bowl (see "Attaching / Detaching
Accessories").

Cleaning and Storage

PLEASE NOTE!
Clean the device immediately after every use to prevent the formation of germs.
Do not use any caustic or abrasive cleaning agents for cleaning. These could damage
the surfaces.
1. Make sure that the device is disconnected from the mains power!
2. If you have not already done so, remove the mixing bowl (10) and the used attach-
ment from the device.
3. Clean the mixing bowl and the attachment with warm water and a little mild detergent.
Off
Slow mixing, stirring and kneading
Fast mixing, stirring and kneading
Pulse (short mode at top speed)
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

0344003550

Table des Matières