Changing The Clipper-Head; Lubrication - Heiniger Saphir Basic Traduction De La Notice Originale

Fig. 17
Fig. 18

6.2.3 Changing the clipper-head

Fig. 19
Fig. 20
6. Fit the favoured clipperhead to the blade hinge and fold it on to the
switched-on clipper by light pressure. (fig. 15, 16, 17).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by a
specialist. In that case, contact your service centre.

6.2.4 Lubrication

To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (fig. 22).
14
1. Move the switch to position "0" (fig.4).
2. Push the battery interlock (2) on both
3. Insert charged battery (1) into the
1. Move the switch to position "0" (fig.4).
2. Push the interlock clipperhead.
3. Fold the clipperhead ahead when
4. Take off the clipperhead.
5. Clean the opened hinge by the help
Translation of the original instructions / Small animal clipper
sides inward and pull the battery (1)
out of the clipper.
shearer (2), until the battery lock is
locked in on both sides.
the interlock clipperhead is pressed.
of the provided brush.