Fig. 10
3. Place the clipper, with the battery inserted, in the charging station so that
the upper part of the clipper is facing towards you and the contacts on the
clipper are resting against the contacts of the charging station. The part
with the switch is the upper part of the clipper (Fig. 10).
4. During the charging process the LED indicator lamp stays lit red contin-
uously. Once the charging process is complete the LED indicator lamp
stays lit green continuously. and the clipper is ready to use. This charging
station has an LED indicator lamp.
6.1.2
Charge battery
Fig. 11
Fig. 12
6.1.3
Fitting the clipper-head
Fig. 13
12
1. Place the charging station on a firm,
2. Plug the charging station in the pow-
1. Test the contacts of the clipper (1)
2. Assure, that the switch lever of
3. Insert the battery (2) in the clip-
1. If the blade hinge (2) is accidental-
Translation of the original instructions / Small animal clipper
even, dry, clean and free under-
ground.
er outlet.
and the battery (2) for foreign parti-
cles and contamination.
the clipper is in OFF-position ("0")
(fig. 4).
per (3), until the battery interlock (1)
is engaged on both sides.
ly closed, lift the latter up using a
screwdriver (1) while simultaneously
pressing the blade lock.