Hitachi C 8FB2 Instructions De Sécurité Et Mode D'emploi page 19

9. Compound cutting procedures
Compound cutting can be performed by following the instructions in 7 and 8 above. At a bevel angle of
45° and a miter angle of 45°, a workpiece of 1-25/32" (45mm) in height and up to 8-21/32" (220mm) in
width can be cut.
CAUTION:
Always secure the workpiece with the right hand side for compound cutting. Never
rotate the turntable to the right for compound cutting, because the saw blade might
then contact the clamp or vise that secures the workpiece, and cause personal injury
or damage.
10. Crown molding cutting procedures
Fig. 27 shows two common crown molding types having angles of (θ) 38° and 45°.
For the typical crown molding fittings, see Fig. 28.
Wall
The table below shows the miter angle and the bevel angle settings that are ideal for the two crown
molding types.
NOTE:
For convenience, positive stops are provided for both the miter setting (left and right 31.6°,
35.3°) and the bevel setting positions (left 30°, 33.9°).
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting side handle
a little to the right and left to stabilize the position and to properly align the miter angle scale and the tip
of the indicator before the operation starts.
For bevel cut setting
Move handle on bevel section to the left and check that the position is stable and that the bevel angle
scale and the tip of the indicator are properly aligned. Then tighten the clamp lever.
To process crown molding at
Type of
positions 1 and 4 in Fig. 28.
Crown
Molding
Miter Angle
Setting
right 35.3°
45° Type
( mark)
right 31.6°
38° Type
( mark)
(1) Setting to cut crown moldings at positions q and r in Fig. 28 (see Fig. 29):
q Turn the turntable to the right and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the left and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the upper surface (A in Fig. 27) contacts the fence as indicated in
Fig. 30.
A upper surface
Ceiling
B lower surface
Wall
Fig. 27
Bevel Angle
Setting
30°
( mark)
33.9°
( mark)
Ceiling
q w e
Fig. 28
To process crown molding at
positions 2 and 3 in Fig. 28.
Miter Angle Bevel Angle
Setting Setting
left 35.3° left 30°
( mark) ( mark)
left 31.6° left 33.9°
( mark) ( mark)
r
English
19