OHAUS TD52 Manuel D'instruction page 5

In the direction of the arrow (from
the bottom up)
V-
V+
GND
I-
I+
GND
6. Fix the cable with the cable tie to avoid falling off from the terminal
block. Put the Interface option cover back on the terminal.
For TD52XW:
1. Remove the interface option cover. Remove the 6 screws with sealed
washers. Remove the M25 hole plug as shown.
Description
Negative voltage output
Positive voltage output
Ground
Negative current output
Positive current output
Ground
Screws
Load cell cable connector
M25 Hole plug
EN-3
Pin
J2
J3
Nylon cable tie