Analog Configuration - OHAUS TD52 Manuel D'instruction

EN-10
7. Fasten the cap nut of M25 gland to rear housing.
8. Warp the rubber seal onto Current Loop Output cable and Push it to the
hole.
9. Fasten the cap nut of M25 gland.

ANALOG CONFIGURATION

Communication
Source
Output Type
Zero Value
Analog
Full Scale Value
Cal Output Zero
Cal Output Full
Options (bold is default)
None, Displayed Weight, ABS-Displayed Weight,
Gross Weight
4-20mA, 0-10V
0 (any valid value below the upper limit)
Desired source value, scale capacity
Cap nut of M25 gland
Rubber seal
Cap nut of M25 gland