Identification Of Manufacturer And Appliance; Procedure For Requesting Service - Angelo Po 0N0FAA Manuel D'utilisation

The nameplate shown here is fi tted directly to
the appliance. It contains references and all es-
sential information for operating safety.
Extra nameplate
A)
a 1 ) Country of use
a 2 ) Appliance category
a 3 ) Type of gas
a 4 ) Gas pressure
a 5 ) Type of fume exhaust vent
Nameplate
B)
b 1 ) Appliance model
b 2 ) Type of customisation
b 3 ) Manufacturer identifi cation
b 4 ) Serial number
b 5 ) Protection class
b 6 ) EC conformity mark
b 7 ) Reference standard
b 8 ) EC certifi cate number
b 9 ) Product family type
b 10 ) Type of gas
b 11 ) Rated power (kW)
GB
See paragraph "PROCEDURE FOR REQUESTING
SERVICE" of the User instructions manual.
3319960_inst_GB_rev.1

IDENTIFICATION OF MANUFACTURER AND APPLIANCE

PROCEDURE FOR REQUESTING SERVICE

b 12 ) Gas consumption
b 13 ) Testing gas indicator frame
b 12,5 ) Voltage (V)
b 15 ) Frequency (Hz)
b 16 ) Electricity power consumption (W)
b 17 ) Test voltage indicator
b 18 ) Date of construction
Testing gas plate
C)
c 1 ) Type of gas
c 2 ) Gas pressure
The installer must select the plate (A)and ap-
ply it alongside the nameplate relating to the
country of use, and must mark the relative ap-
pliance class (Type A = standard fume exhaust
vent).
If the appliance is to be used with the same type
of gas as used by the manufacturer for testing,
the installer has to remove the plate (C) and ap-
ply the indicator
(b13)
for use on the nameplate.
- 4 -
against the data of the gas
ENGLISH