Identification Of Manufacturer And Appliance; Procedure For Requesting Service - Angelo Po 0N0FAA Manuel D'utilisation

IDENTIFICATION OF MANUFACTURER AND APPLIANCE

The nameplate shown here is fi tted directly
to the appliance. It contains references and all
essential information for operating safety.
Extra nameplate
A)
a 1 ) Country of use
a 2 ) Appliance category
a 3 ) Type of gas
a 4 ) Gas pressure
a 5 ) Type of fume exhaust vent
Nameplate
B)
b 1 ) Appliance model
b 2 ) Type of customisation
b 3 ) Manufacturer identifi cation
b 4 ) Serial number
b 5 ) Protection class
b 6 ) EC conformity mark
b 7 ) Reference standard
b 8 ) EC certifi cate number
b 9 ) Product family type
b 10 ) Type of gas
b 11 ) Rated power (kW)
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
When requesting after-sales service, state
the data provided on the nameplate (see
"equipment and manufacturer identifi cation" in
the oven manual) and the type of fault noticed.
3319960_ut_GB_rev.1

PROCEDURE FOR REQUESTING SERVICE

b 12 ) Gas consumption
b 13 ) Testing gas indicator frame
b 14 ) Voltage (V)
b 15 ) Frequency (Hz)
b 16 ) Electricity power consumption (W)
b 17 ) Test voltage indicator
b 18 ) Date of construction
Testing gas plate
C)
c 1 ) Type of gas
c 2 ) Gas pressure
The installer must select the plate (A)and apply
it alongside the nameplate relating to the
country of use, and must mark the relative ap-
pliance class (Type A = standard fume exhaust
vent).
If the appliance is to be used with the same
type of gas as used by the manufacturer for
testing, the installer has to remove the plate (C)
and apply the indicator
of the gas for use on the nameplate.
- 3 -
against the data
(b13)
ENGLISH
GB