HumanTechnik LISA A-2124-0 Mode D'emploi page 9

Congratulations on purchasing the
lisa flash lamp . We hope it will provide
you with many years of ser vice. You
have chosen a modern and reliable
system.
Please read through these operating
instructions carefully. They tell you how
to set up the system correctly and
explain all the system's features to you.
Standard components
Please check if all following compo-
nents are included:
- lisa flash lamp
- Operating instructions
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Functional principle
An alerting system requires at least
one transmitter and a receiver. The
transmitter captures signals and
transforms them into digital signals
that are passed to a receiver by the
existing mains electricity supply. The
receiver then transforms these digital
signals into light signals.
Channel selection
A digital transmission system ensures
the correct recognition of each of the
digital signals from each transmitter.
The system has 10 different selecta-
ble channels, 0-9. The factory setting
for all lisa devices is channel 0. Only
where more than one installation is
required in the same building, it will
be necessary to select a different
channel for each system.
To select a channel, turn the rotary
switch on the underside of the trans-
mitter to the required channel number
using a small screwdriver.
All transmitters and receivers must be
set to the same channel.
Example: Set channel number 0
English 9