Setting The Scale - Domo DO9099W Mode D'emploi

DO9099W
at the bottom of the scale you can select the weighing unit kg or
lb. turn on your scale. turn it over and press the button next to the
battery compartment. Kg or lb will appear on the display, below the
weight indication.
USING THE SCALE WITHOUT MEASUREMENTS
1. Briefly stand on the scale to turn it on.
2. step onto the scale again.
3. once the scale has determined your weight, the numbers will start blinking.
SEqUENTIAL ADDITIONAL WEIGHING
once you have determined your weight, it is possible to determine additional weight
without stepping off the scale.
For example:
• you have measured your weight and you want to weigh an object.
• Keep standing on the scale and grab the object.
• the scale will automatically adjust the weight.
• By substracting your own weight from the total weight, you are able to determine
the weight of the object.
Briefly stand on the scale to turn it on. The display will now show 0.0.
• at this point you can start setting parameters for a new user or if you have already
set up a user, you can now select the right user memory. you can select the
memory by pressing the set button for a few seconds and by using the up and
down arrows.
• there are 12 memories for 12 different users available.
• Briefly stand on the scale to confirm the memory selection.
setting the user memory:
1.
press the set button for a few seconds. the number 1 will
start blinking.
2. press the set button to adjust this user memory. the
standard settings will contain the following values:
gender: male
height: 165 cm
age: 25
3. the gender will start blinking. press the up or down arrow to
set the gender to male or female. press the set button to
CHOOSING THE WEIGHING UNIT

SETTING THE SCALE

36