Polycut 2-2 Mowing Head - Stihl FSA 45 Notice D'emploi

7 Assembling the Trimmer
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2

PolyCut 2-2 Mowing Head

7.2.1 Fitting Mowing Lines
► Switch off the trimmer and remove the activation key.
► Place mowing lines in a container filled with water for 12
to 24 hours before using.
This makes the nylon mowing lines supple.
1
► Push mowing line up through the right opening from
below.
0458-718-9621-A
3
2
2
► Thread the mowing line through the left opening from
above until the end of the line reaches the symbol.
► Hold the short end of the mowing line firmly.
► Pull the long end of the mowing line until it is tight against
the mowing head.
► Cut the mowing lines so that they extend as far as the line
limiting blade.
7.2.2 Removing Mowing Lines
► Switch off the trimmer and remove the activation key.
► Push the short end of the mowing line upwards out of the
mowing head.
► Pull the short end of the mowing line upwards out of the
mowing head.
► Pull the mowing line out of the mowing head.
7.2.3 Mounting the Blades
► Switch off the trimmer and remove the activation key.
► Place blades in a container filled with water for 12 to 24
hours before using.
This makes the blades supple.
English
41