Trevi HCX 10D6 DAB Mode D'emploi Et Connexion page 14

ENGLISH
Software upgrade: allows you to perform a scan to check for any updates available for the device.
SW version: allows you to view the software version of the device.
DAB/DAB+ DISPLAY MODE
Every time you press the INFO button (23) on the remote control, the display will cycle through the following display modes.
DLS: Dynamic label segment is a scrolling message that the broadcaster may include with their transmissions . This message
usually includes information, such as program detail etc...
Program Type: This describes the "Style" or "genre" of music that is being broadcast e.g. "Rock "or "Classical".
Channel Frequency: Displays the current DAB multiplex in use.
Signal error index: displays information relating to the level of signal errors and the intensity with which it is received.
Bit Rate: displays information related to the compression ratio of the current transmission.
Time: displays the time signal received by the radio station.
Date: displays information about the date.
FM RADIO OPERATION
1. Switch on the appliance and press repeatedly the FUNC button (15) on the remote control until the FM indication appears on
the display;
2. Press the buttons :
increase or decrease the frequency 0,05MHz and perform a step-by-step search;
3. Hold down for a few seconds the buttons
control to tune into the next station or previous radio station with the best signal received;
4. To activate the automatic search and memorization of radio stations (SCAN) function, press the button
control or press the MENU button (21) to access the FM menu. Search for and select the word "Scan setting";
from this item it is possible to select the type of automatic search: select STRONG (stations with strong signal) or ALL (all
stations), confirm with the
The device is capable of storing up to 30 stations.
5. To store a radio station:
- Go to the frequency to be memorized and keep the PROG key (24) pressed for a few seconds, the display will show
the wording "PRESET STORE";
:
- Use the keys

- Press (19) to confirm.
6. To call up a stored radio station use F+/CH+(28) and F-/CH-(27) buttons.
Note: To get the best FM reception connected and oriented the antenna. If reception is not good try to adjust the length and orien-
tation of the antenna differently, however the quality of FM reception depends very much on the place where the device is placed.
CD-MP3 PLAYER OPERATION
1. Switch on the appliance and press the FUNC key (15) on the remote control several times until CD appears on the display. If
there is no disc, the indication "NO DISC" will appear on the display;
2. Open the CD compartment (8) by pressing the button
facing up. Gently close the compartment;
3. After a few seconds the display will show the number of tracks on the disc. Press the button
to start music playback;

4. Press the button
Press it again to start normal playback;
5. Press the button (22) on the remote control to stop playback permanently.
JUMP TRACE AND QUICK SEARCH
1. Press : (4) and 9 (3) on the unit, or the
track;
2. Press and hold : (4) and
quickly search a particular musical passage. Release the button to return to normal playback.
14
(4) and 9 (3) on the unit repeatedly, or the
:
(4) and
 (19) on the remote control.
9
(26) and (20) to select a memory location;
(19) on the remote control again to activate the pause, the elapsed time of the track will start to flash.
: (26) and
9 (3) on the unit, or the
: (26) and
9
(3) on the unit, or the
(29) on the remote control and insert the disc with the written side
9 (20) buttons on the remote control to move to the previous or next
: (26) and 9 (20) buttons on the remote control during playback to
HCX 10D6 DAB
9 (20) buttons on the remote control to
: 9
(26) and (20) buttons on the remote

(19) on the remote
 (19) on the remote control