Maintenance - Panasonic SC-HC27 Manuel D'utilisation

Disc
Display not shown correctly.
Playback does not start.
• You did not put the disc in correctly. Put it in correctly.
• Disc is dirty. Clean the disc.
• Replace the disc if it is scratched, warped, or
non-standard.
• There is condensation. Let the system dry for 1 to 2 hours.
Radio
A beat sound is heard.
• Switch off the TV or move it away from the system.
• Move mobile telephones away from the unit if the
interference is apparent.
Stations cannot be selected.
• Change the FM frequency step (Z page 7).
Main unit displays
"--:--"
• You connected the AC power supply cord for the first time
or there was a power failure recently. Set the clock.
"ADJUST CLOCK"
• Clock is not set. Adjust the clock accordingly.
"ADJUST TIMER"
• Play timer is not set. Adjust the play timer accordingly.
"DIMMER"
• 10 seconds after the volume is set to "0", the brightness of
the display panel is decreased.
"ERROR"
• An incorrect operation was done. Read the instructions
and try again.
"F61"
• There is a power supply problem.
"IPOD OVER CURRENT ERROR"
• The iPod/iPhone is drawing too much power. Remove the
iPod/iPhone. Switch the system off and on again.
"NODEVICE"
• The iPod/iPhone is not connected. Examine the
connection.
"NO DISC"
• You have not put in a disc.
"NO PLAY"
• You have put in a disc that the system cannot play.
"NOT SUPPORTED"
• You have inserted an iPod/iPhone that cannot be played.
• If the iPod/iPhone is compatible, remove the iPod/iPhone
and connect it again. Examine that the battery of the iPod/
iPhone is not depleted.
HC27_PC_1en.indd 9 HC27_PC_1en.indd 9
Memory reset (initialization)
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
Wait 3 minutes before you continue with step 2.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
"– – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
To set the code to "REMOTE 2"
1
Press and hold [CD] on the main unit and [R] on
the remote control until "REMOTE 2" is shown.
2
Press and hold [OK] and [R] for a minimum of
4 seconds.
To set the code to "REMOTE 1"
1
Press and hold [CD] on the main unit and [T] on
the remote control until "REMOTE 1" is shown.
2
Press and hold [OK] and [T] for a minimum of
4 seconds.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the instructions
that came with the cloth carefully.
9
9
12/22/2011 11:27:21 AM 12/22/2011 11:27:21 AM