Hotpoint Ariston SL B18 AA0 Mode D'emploi page 18

We advise you to unwind the entire
power cord (app. 7m) to avoid any
overheating and damage.
2. Press the start/stop button (18) to start the
appliance.
3. Press the Trolley System opening/closing
button (12) to extend the carrying handle
(11) to the desired length until it locks into
place. Then manoeuvre the vacuum cleaner
using the carrying handle when cleaning the
house.
4. To select the desired suction intensity
(based on the model) use the +/- button
and electronically adjust the power (20)
of the Remote Power Control; or manually
rotate the electronic power regulator (25).
We advise you to use a low suction
power on delicate surfaces such as
curtains, fabrics, cushions etc to avoid any
damage; or at least open the air regulator to
reduce the suction effect.
5. To pause the vacuum cleaner, if this feature
is available, you can use the standby button
(21) on the Remote Power Control or the
Start & Stop function (based on the model).
Just insert the brush into its horizontal
housing (29).
6. To switch off the appliance press the start/
stop button again.
7. Disconnect the plug from the electrical
outlet and press
button (19) until rewinding is complete.
Make sure the cord does not get
entangled during rewinding.
8. Secure the floor head into its horizontal /
vertical housing and store the appliance.
Do not start the vacuum cleaner if the
plastic flexible hose is entangled, as this
could damage the appliance.
featureS
trolley System (B)
The Trolley System allows you to move your
vacuum cleaner easily when cleaning and carry it
from room to room effortlessly.
1. Press the opening/closing button on the
the cord-rewind
Trolley System (12) to pull out the carry
handle (11) until it locks into place at the
desired length.
2. Having completed your cleaning, press
the opening/closing button on the Trolley
System and close the carrying handle until
it locks into place.
use the trolley System's carrying
handle to store the appliance, making
sure you have correctly locked it into place.
remote Power Control (C)
The Remote Power Control (if available) enables
you to adjust the suction power directly and
effortlessly from the hand grip (9), with no need to
bend. When using the vacuum cleaner, you can
keep it on standby by pressing the standby button
(21).
To insert or change the batteries of your Remote
Power Control:
1. Open the battery compartment (22).
2. Insert two AAA batteries, making sure of the
positive and negative poles.
3. Close the battery compartment until it clicks
into place.
Start & Stop (D)
The Start & Stop function (if available) lets you
keep the vacuum cleaner on stand-by and lock
the cleaning head in the park position: just insert
the brush into its horizontal housing (29).
Dual System (e)
The Trolley Dual Clean version of the Trolley
Power makes your use of the appliance extremely
versatile because it can be used with or without
dust bag. Just assemble the conversion kit in the
package: it comprises a Pure Clean dust bag (34),
dust bag support (33), gasket (37), and motor
filter grill (36) already fitted to the motor filter (35).
The assembling takes place as follows:
1. Make sure the appliance is disconnected
from the electrical outlet.
2. Press the dust-compartment opening button
(13) to open the dust compartment lid (14)
and remove the dust container (39).
3. Fit the gasket into the special groove along
the perimeter of the dust compartment (38).
4. Fit the motor filter grill (already fitted to
en
eu
hotpoint.
17