Place Your Soundstage - Philips HTB3525B Manuel D'utilisation

3 Place your
SoundStage
This SoundStage is designed to be placed under
your TV.
Caution
•
The SoundStage is designed for TVs that weigh no
more than 22 kg. Most 42" or smaller TVs and some
of 55" TVs meet this requirement. Do not place a CRT
type TV on the SoundStage.
•
Do not place the SoundStage on an unstable cart,
stand, bracket or table. Otherwise, the SoundStage may
fall, causing serious injury to a child or adult and serious
damage to the product.
•
Make sure the ventilation openings on the rear panel
are not blocked.
•
Do not change the position of the SoundStage after
placing your TV on top of it.
1
Place the SoundStage on any flat and
stable surface near your TV. Then place
your TV on the top of the SoundStage.
2
Make sure the TV base is centered on it
and not hanging over any of its edges.
EN
8
HTB3525B_F7_UM_V1.0.indb 8
Tip
•
If the TV base is too large to put on top of the
SoundStage, place the SoundStage in another location
such as on an open shelf under the TV, but keep it close
to your TV so the audio cable will reach. You can also
mount your TV on the wall above the SoundStage.
•
If your TV comes with an anti-tip device, install it
according to the manufacturer's instructions and adjust
the tether after placing the TV on top the SoundStage.
•
If placing the SoundStage in a cabinet or on a shelf, for
optimum audio performance, make sure the font of
the SoundStage as close as possible to the front edge
of the shelf.
•
If placing the SoundStage backed up to a wall, make
sure there is at least a distance of 1 inch between the
wall and the rear of the SoundStage.
12/10/2013 6:03:57 PM