Start; Working Mode Definition; Manual Mode Comfort; Manual Mode, Reduced - Watts Industries BT DRF-01 Guide D'utilisation

- Now on the thermostat press and maintain the
edition key ( ) during 10s, then the parameter «
ini » must be display.
The thermostat will send now the radio
configuration signal to the receiver.
- On the receiver check the good reception
(generally showed by a green LED blinking). Once
the configuration between the receiver and the
thermostat made, press on the escape key (
come back to the main screen.
- Now you can check the RF distance, go to the
room which must be regulated. Put your thermostat
13
3.1

Manual mode Comfort

Manual working mode, the comfort setting
temperature will be followed all the time.
By pressing (-) or (+) keys, the comfort setting
temperature starts to blink and can be adjusted.
3.2

Manual mode, Reduced

Manual working mode, the reduced setting
temperature will be followed all the time.
By pressing (-) or (+) keys, the reduced setting
temperature starts to blink and can be adjusted.
16
on the final position (On the wall or table...), then
put the thermostat in Comfort mode (setting
temperature position 37°C). Close the door and go
to the receiver to check if the new status of the
thermostat has received. (The heating is generally
showed by a Red LED).
- Now return to the thermostat and switch off it.
Check on the receiver again if it's also switched off
(The red LED must be turned off)
If the RF signals were received correctly,
o
adjust your setting temperature as you want.
If the RF signals weren't received correctly,
o
check the installation (Receiver position,
distance...)
) to
* To make the installation easier it will be better to
have the thermostat near to the receiver during the
configuration mode. (A minimal distance of >
1meter must be respected)
3.3

OFF mode

Use this mode if you need to switch off your
installation.
Be Careful:
In this mode your installation can freeze.
- At any time, when display is off, press on the (Ok)
key to display a few seconds the current
temperature and time.
- To restart your installation, use the navigation
keys (◄) or (►).
3.4

Anti-freeze mode

Use this mode if you want to protect your
installation against freezing. (During holidays...)
14
17
2.3

Start

The thermostat is now ready to works.
The default working mode will be Comfort

Working mode definition

3.
How to change the working mode?
- Open the small center cover to have access to the
navigation keys (◄) or (►).
- You can now press theses keys to display the
working mode line.
Move the frame cursor on the desired working
mode and press (OK) to enter in the operating
mode you have chosen.
15
- The anti-freeze setting temperature is fixed and
can be adjusted in the parameter menu number
06 'HG', see chapter 6. (Default value 10°C)
3.5

Timer mode

The Timer mode allows you to adjust, the
temperature and the duration for a special time.
This function can be used when you stay at home
for several days, or if you want to override the
program for some time (reception...)
- You can first adjust, the desired setting
temperature with (-) or (+), press (OK) to start the
function. (Default value 22°C)
- In a second time, you can adjust the duration in
hours "H" if below 24H, then in day "d" with (-) or
(+), press (OK) to validate.
18