Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump .
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
General Safety
1. To avoid risk of serious bodily injury and property
damage, read the safety instructions carefully before
installing this pump.
2. Follow local and/or national plumbing, building and
electrical codes when installing the pump.
3.
Risk of explosion . Do not ground to a
gas supply line.
• Use high pressure reinforced type discharge hose
ONLY. See parts list for available hose, nozzle and
fittings. A high pressure relief valve is recommended.
• DO NOT use garden hose with High Pressure
Booster pump. Garden hose will not stand the
discharge pressure produced and will fail.
• High pressure discharge stream is dangerous. To
avoid injury, DO NOT aim the discharge stream at
any person or animal.
• BE SURE that the pump suction pipe pressure plus
the pump discharge pressure does not exceed the
pressure rating of hose and fittings. See Table I for
pump discharge pressure ratings.
4.
Risk of fire and explosion . Can cause
severe injury, property damage or death. To avoid
risk of fire and explosion, Pump Water Only with
For parts or assistance, call Flotec Customer Service at
this pump. Do not pump flammable liquids or
chemicals. Do not use the pump near gas pilot lights
or where chemical or gas fumes are present. Use of
an electric pump with liquids other than water or
in an atmosphere containing chemical or gas fumes
may ignite those liquids or gases and cause injury or
death due to an explosion and/or fire.
5.
Risk of burns . Never run the pump
dry. To do so can damage internal parts, overheat
pump (which can cause burns to people handling or
servicing pump), and will void warranty.
• If water is trapped in the pump during operation it
may turn to steam. Trapped steam can lead to an
explosion and burns. Never run the pump with the
outlet closed or obstructed.
• Do not touch an operating motor. Modern motors
can operate at high temperatures. To avoid burns
when servicing the pump, allow it to cool for 20
minutes after shut-down before handling.
Electrical Safety
Risk of electric shock . Can shock, burn or
kill. Ground the pump before connecting to a power
supply. Disconnect the power before working on the
pump, motor or tank.
• The pump is non-submersible. Keep the motor dry at
all times. Do not wash the motor. Do not immerse.
Protect the motor from wet weather.
• Disconnect power to the pump before servicing.
• Disconnect the power to the pump before servicing
the pump. After the power is disconnected, let the
pump cool for 20 minutes before attempting to work
on it.
• Take extreme care when changing fuses. To reduce
the chance of fatal electrical shock, DO NOT stand
in water or put your finger in the fuse socket.
• Ground the electrical outlet box.
800-365-6832
2
Publicité
Table des Matières
