Safe Operation Of The Unit - Oase Jumping Jet Rainbow Star Set Notice D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
- GB -
Route the connection cable so that damage is excluded.
Keep all connection points dry. Risk of electrocution.
Operation of the 12V Master control box is only allowed with the protection hood closed. In this
manner, connections and plugs are protected from rain and splash water (type of protection IP X4).
The 12V Master control box, the connections and plugs are not water-proof and must not be routed
or installed in water.
Pos: 110 /Pumpen/Schlammsauger/Jumping Jet Rainbow Star/SIC Sicherer Betrieb des Gerätes @ 7\mod_1196624794946_121.doc @ 41365
4.3

Safe operation of the unit

Only operate the Jumping Jet Rainbow Star when no-one is in the water.
Do not carry or pull the units by the power cable.
Do not operate defective units. Never operate the unit if either the cable or the housing is defective!
Pull the power plug immediately. Repairs of connection cables may only be carried out by the manu-
facturer / supplier.
Position the Jumping Jet Rainbow Star such that danger of injury to persons is excluded (e.g. cau-
ses by a water jet or light beam suddenly emerging).
Never look directly into the water jet outlet opening or into the light source of the Jumping Jet Rain-
bow Star.
Because of its weight, always have two persons carry the Jumping Jet Rainbow Star.
Avoid vibrations and impacts in order not to damage the drive unit and the electronics in the Jum-
ping Jet Rainbow Star.
Never open the housing or its attendant components, unless this is explicitly mentioned in these in-
structions of use.
Always pull the power plugs of all units located in the water prior to starting work on the Jumping Jet
Rainbow Star.
The Jumping Jet Rainbow Star is not suitable for dry installation. The water exits the container via a
lateral bypass when no water jet is produced. It must be guaranteed that the emerging water can re-
turn to the point from which it was taken.
Where the water jet hits the water surface, the water depth must be at least 300 mm to avoid heavy
water splashes. During operation, the point where the jet hits the water surface could vary, depen-
ding on the degree of clogging of the filter and screen.
This point should not be too close to the basin rim (> 1 m). Never guide the water jet beyond the ba-
sin rim, as in this case splash water cannot be avoided.
Never connect the unit to the domestic water supply.
Adhere to the maximum water level height specified in these instructions of use.
The cleaning interval of filter and screen in the Jumping Jet Rainbow Star depends on the quality of
the water supplied.
During the frost period, take the Jumping Rainbow Star out of operation and store it at a frost protec-
ted place.
Clean the suction filter basket of the connected pump at regular intervals.
Pos: 111 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jumping jet rainbow star add-on set

Table des Matières