Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LifeBook S760 Mode D'emploi

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with a minimum of 1GB of high speed Double Data Rate 3
Synchronous Dynamic RAM (DDR3-1066 SDRAM) factory installed. To increase your notebook's memory
capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-
line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from
the Fujitsu web store at www.shopfujitsu.com

Installing Memory Upgrade Modules

1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Turn the notebook bottom side up, and remove the screw from the memory upgrade module compartment.
3
Remove the cover.
4
Remove the memory upgrade module from the static guarded sleeve.
5
Align the memory upgrade module with the component side up. Align the connector edge of the module with
the connector slot in the compartment. Be sure the alignment keys line up with those in the slot.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
(ESD). T
O MINIMIZE RISK TO THE MODULE
-- B
EFORE HANDLING A MEMORY MODULE
ELECTRICITY BUILT UP IN YOUR BODY
-- W
HEN INSTALLING OR REMOVING A MEMORY MODULE
ANY CONTACTS OR CHIPS
;
COMPONENTS THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
-- B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
IF THE SYSTEM IS IN HIBERNATE OR STANDBY STATES
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
82 - Memory Upgrade Module
.
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC
.
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH
,
DATA COULD BE LOST OR THE MEMORY
.
:
.
. E
VEN