Technical Data And Overal Dimensions; General Information; Trasportation And Movement - Rivacold ST Mode D'emploi Et D'entretien

UK
3.10 Technical Data and Overall Dimensions
The technical features of the machine are found in Chapter 9 – Attachments in this handbook.
4 . T r a n s p o r t
4 . T r a n s p o r t

4.1 General information

The installation and possible re-installation of the machine must be conducted directly by qualified staff.
Before proceeding to installing the machine, it is necessary to prepare the power supplies and utilities necessary for the correct
functioning of the system, following the indications reported in this chapter and, if necessary, consulting the manufacturer's
Technical Office in advance.
ATTENTION:
DANGER:
4.1.1 Power and Utilities
The power supplies and utilities necessary (responsibility of the purchaser) for machine functioning exclusively consist in the supply
of electrical energy.
Unless otherwise indicated, the purchaser is responsible for:
the preparation of transport vehicles to transport the machine to the assembly or installation location;
the preparation of equipment necessary for assembly and installation;
the preparation of the installation location;
the preparation of auxiliary vehicles and consumable materials (for example, non-flammable and non-corrosive detergents,
materials and tools necessary for cleaning and cover).
4.2 Transportation and Movement
The information contained in this paragraph is required when the machine is transported and handled during the situations below
described:
storage of the machine;
assembly and initial installation of the machine;
un-installation and disassembly of the machine;
movement and relocation of the machine.
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
During machine transportation or handling it is necessary to follow the instructions below:
check that the lifting equipment is suitable for the machine's size and weight (check the specifications of the Blocksystem ST-
SP type as stated in Chapter 9 - Attachments).
Do not damage whatsoever the machine's structure or guards with tools.
Picture 2 – Position of the identification plate CE.
Label
a n d I n s t a l l a t
a n d I n s t a l l a t
This product as sold complies with the 97/23CE (PED) standard and is marked with the relevant
category. After purchase it is the responsibility of the owner to ensure that this equipment is regularly
maintained continue its compliance up to the stage when it is finally decommissioned according to the
relevant national law.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
the Manufacturer cannot be held responsible for any damage to property and/or people arising from
improper operations carried out by unqualified, untrained or unauthorized staff.
i o n
i o n
Label
ST-SP Pag. 44 Rev 02 05/13