Calls Between Radios; Sending A Call Signal - switel WT010 Mode D'emploi

4.4

Calls between radios

To speak yourself, press the PTT talk button on the left-hand side. Hold
the unit about 5 cm from your mouth and speak in a normal voice. When
you have finished, release the talk button. The person you are speaking to
will hear a signal tone (Roger beep) when you have released the talk
button. This will indicate to the other subscriber that you have finished
speaking and are waiting for a reply.
Note: Remember that all radios, which are set to the same
channel and are within receiving range, will be able to hear your
call at the same time.
15 volume levels can be set using the
Note:
- While you are holding the talk button, you will not be able to
hear any incoming calls. As is usual with radio units, only one of
the two participants in the call can speak at any one time.
- In order that a radio channel is not engaged for too long, you
can keep the PTT talk button pressed for up to 60 seconds.
After this, the radio will switch off the transmission and you will
hear a signal tone.
Therefore, always wait until you hear the signal tone before pressing the
talk button again.
4.5

Sending a call signal

You can summon the attention of the person you are calling by means of
the call signal. Press the call button
the unit called. Remember that call signals will sound on all radios that are
within receiving range. Now wait until the person called answers.
40
- Operation -
+
once. A signal tone will sound on
and buttons.