Changing The Moulded Grip - switel WT010 Mode D'emploi

3.4

Changing the moulded grip

Your radios are each supplied with three coloured moulded grips, which
you can change as required. To change the moulded grip, proceed as
follows:
Removing the grip
1. Remove the belt clip (see 3.3) and open the battery compartment.
2. Now carefully lever the moulded grip out of the fixing at position 1
using a screwdriver.
3. Repeat this procedure at positions 2 and 3.
4. You can then remove the moulded grip.
Fitting the grip
1. Take the new grip and push the two upper ends into the openings
provided.
2. You can then push the grip home at the other positions.
3. Close the battery compartment and re-fit the belt clip.
38
- Setting up -
2
3
1