Setting Up; Check Contents Of Pack; Fitting The Batteries; Removing And Fitting The Belt Clip - switel WT010 Mode D'emploi

3

Setting up

3.1

Check contents of pack

The following items are supplied:
two radios with belt clip
one instruction manual
3.2

Fitting the batteries

The batteries required are not supplied with the unit. For each unit you will
require three type AAA 1.5V batteries. Please use new high-quality
alkaline batteries.
Note: You can also use rechargeable NiMH batteries with a capacity of
600mAH. Rechargeable batteries cannot be charged while in the radios.
1. To release the belt clip, pull gently on the upper tab and slide the belt
clip upwards (see 3.3).
2. Then open the compartment by sliding the cover downwards.
3. Now insert the batteries taking care to ensure that the polarity is
correct. Incorrect polarity can damage the unit.
4. Close the battery compartment and re-fix the belt clip (see 3.3).
If the batteries are discharged, you will hear signal tones or it will no
longer be possible to switch the radio on.
3.3

Removing and fitting the belt clip

To release the belt clip, pull gently on the upper
tab (1) and slide the belt clip upwards (2).
Slide the belt clip into the guide from above until
it audibly engages (2).
If the t belt clip should not engage firmly, press the small latch with the
fingernail against the back of the radio.
- Setting up -
three moulded grips for each radio
1
2
37