Sony WAHT-SA20 Mode D'emploi page 10

S-AIR/
STANDBY
indicator
Flashes orange.
Flashes red.
About the standby mode
The surround amplifier enters standby mode
automatically (the S-AIR/STANDBY
indicator turns red) when the main unit is in
standby mode or wireless transmission is
deactivated.
The surround amplifier is turned on
automatically (the S-AIR/STANDBY
indicator turns green) when the system is
turned on and wireless transmission is
activated.
For details, see "Troubleshooting"
(page 11).
Note
• Depending on the main unit, the surround
amplifier may not enter standby mode
automatically or may not turn on automatically.
In this case, press ?/1 (Power) on the surround
amplifier to change the power mode.
Preventing transmission
to neighbors (Pairing)
If your neighbors also have S-AIR products
and their IDs are the same as yours, your
neighbors could receive the sound of your
S-AIR main unit. To prevent this, you can
identify your S-AIR products by performing
the pairing operation.
x Before the pairing operation
(example)
The sound transmission is established by the
ID.
10
US
Status
The wireless transceiver is
not connected to the
surround amplifier.
The surround amplifier's
protection is active.
Your room
S-AIR main unit
ID A
ID A
Surround
amplifier
x After the pairing operation
(example)
Sound transmission is established between
the surround amplifier and the S-AIR main
unit that performed the pairing operation.
Your room
S-AIR main unit
ID A
ID A
Surround
amplifier
Pairing
1
Turn on the S-AIR main unit and
the surround amplifier.
The system turns on.
2
Match the IDs of the S-AIR main
unit and the surround amplifier.
Neighbor
ID A
Other S-AIR
products
Neighbor
No transmission
ID A
Other S-AIR
products