GB
10. The 0.35mm² brown-white single wire is used for vehicles with parking aid (APS). In this case
this wire is attached to the parking aid's control unit (APS, rear left side panel). (Refer to
operating manual of the parking aid/APS or contact a garage.)
This single brown-white wire is not used in vehicles that don't have parking aid (APS).
Secure the placed wires and fuse holder with cable binders.
Re-install removed parts, re-connect the battery's negative terminal.
Check all functions with a suitable testing instrument (with load resistance) or with a towed ve-
hicle!
Allocation of the 7-pin socket
Circuit
Left turn signal lamp
Rear fog lamp
Earth (circuit 1-8)
Right turn signal lamp
Right tail light
Stop light
Left tail light
Allocation of the 13-pin socket
Circuit
Left turn signal lamp
Rear fog lamp
Earth (circuit 1-8)
Right turn signal lamp
Right tail light
Stop light
Left tail light
Back light
Continuous positive
Charge line
Not assigned
Not assigned
Earth (circuit 9-12)
The unassigned 3-pin socket is used to adapt a separate continuous positive wire set. If
needed, this can be purchased at a Westfalia dealer under the part number 300 025 300 113
300027 300113 .
Subject to modification!
10
Wire
black/white
white
brown
black/green
gray/red
black/red
gray/black
Wire
black/white
white
brown
black/green
gray/red
black/red
gray/black
green
red
yellow
brown/white
--
brown
Contact
1/L
2/54g
3/31
4/R
5/58R
6/54
7/58L
Contact
1
2
3
4
5
6
7
8
9
10
11
12
13