Properties Of The Product - VITRA AQUACARE Guide Utilisateur

is recommended. If the temperature of the water used exceeds 60⌐ C and the water used is
very hard, the product may be calcified within a short period of time. The table of measures
required to be taken as specified in the Table.6 in the document DIN 1988-200 is given below:
The water hardness levels determined by WRMG are as follows:

Properties of the Product

Aquacare is a toilet bowl which has the lower washing (cleanse) function. The washing water is
supplied to the toilet bowl through an angle valve and comes out of the hole on the toilet
rosette. The water discharge angle can be adjusted by turning the discharge end.
The user, when desires, turns on the angle valve and ensures that the water comes. When
washing with water is completed, the user turns off the angle valve and cuts off the water.
Aquacare has a special injector for the protection of the drinking water installation. The water
that comes from the angle valve enters into this injector in the first place and the water that
comes out of the injector is transferred to the toilet rosette from the behind of the toilet bowl.
The drinking water protection injector is located under the cover that is situated on the hinge
axis of the toilet cover. This assembly prevents the backward flow of the water by a completely
mechanical method without using any electric supply.
During turning on and turning off the water, several drops of water fall from the apparatus that
prevents the backward flow of the water. The water that falls is discharged into the clean water
canal of the toilet bowl and transferred into the reservoir. The dropping water is not seen by the
user because it remains under the cover.
14