Monacor International 38.7010 Mode D'emploi page 14

5.3.2 Transferring unit settings to other
GB
ODP-1910RGBW
All settings and programs (with the exception of
the DMX start address and the colour tempera-
ture) can be transferred to other ODP-
1910RGBW if they are connected with each
other via the DMX connections.
1) If a DMX light controller is connected: First
disconnect the DMX light controller from the
ODP-1910RGBW.
2) For the transfer, select the menu items
©
and then press the button ENTER.
5.3.3 Reset (restart)
If the unit cannot be properly controlled during
operation, it may be restarted without switching
the power supply off and on: Select the menu
©
items and press the button ENTER.
After restart, the DMX mode will be switched on.
In the DMX mode (7-channel mode, 10-chan-
nel mode), the light effect panel can also be reset
via the light controller (
line).
5.3.4 Resetting the unit to its factory settings
The factory settings of the light effect panel are
as follows:
Function
colours for the colour radiation mode
©
/ / /
stroboscope for the colour radiation mode
©
colour temperature
© ©
/ /
use of the colour temperature setting
© ©
number of DMX channels
©
response of LEDs
©
display behaviour
speed of a program AT 01 – 05
selected via
“
factory settings
To reset unit panel to its factory settings, select
©
the menu items
press the button ENTER.
4.3.5 Showing unit information
To show various unit information, go to the menu
item , select the following submenu items
and then press the button ENTER:
– software version
– number of individual LEDs
– maximum possible LED brightness (in %)
In normal operation, 100 % is displayed;
in case of overheat, the maximum LED
brightness will be reduced in steps to
80 % and 50 %.
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
14
6
Data protocol: . . . . . . . . . . DMX 512
Number of DMX channels: 4, 5, 7 or 10
Light source: . . . . . . . . . . . 19 RGBW LEDs
power of each LED: . . . 8 W
beam angle: . . . . . . . . . 40°
Power supply: . . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . . 150 VA max.
Protective class
of housing: . . . . . . . . . . . . IP 65
Ambient temperature
range: . . . . . . . . . . . . . . . . -20 °C to +40 °C
Dimensions without
mounting brackets
(W × H × D): . . . . . . . . . . . 210 × 210 × 275 mm
Weight: . . . . . . . . . . . . . . . 9.2 kg
Accessories supplied: . . . . mains cable, 110 cm
table in fig. 7, last
Subject to technical modification.
Factory setting
000
000
255
/
no
10 CH
slightly slow
extinguishes 2 min.
after a button was
pressed
fast
000
©
and then
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
Specifications
DMX cable, 70 cm