Bosch GEX 125-1 A Instructions D'emploi page 15

OBJ_BUCH-315-002.book Page 15 Monday, June 11, 2007 12:59 PM
Technical Data
Random Orbital Sander
Article number
Rated power input
Preselection of orbital stroke rate
No-load speed
Orbital stroke rate
Orbit diameter
Sanding plate diameter
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined
EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 77 dB(A); Sound power
level 88 dB(A). Uncertainty K =2.8 dB.
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration emission value a
2
K =1.5 m/s .
The vibration emission level given in
WARNING
this information sheet has been
measured in accordance with a standardised test
given in EN 60745 and may be used to compare one
tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information
sheet. This could lead to a significant underestimate
of exposure when the tool is used regularly in such a
way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the times
when the tool is switched off and when it is running
but not actually doing the job. This may significantly
reduce the exposure level over the total working
period.
2 609 140 411 • 11.6.07
Declaration of Conformity
according to We declare under our sole responsibility that the
product described under "Technical Data" is in con-
formity with the following standards or standardization
documents: EN 60745 according to the provisions of
the directives 89/336/EEC, 98/37/EC (until Dec. 28,
2009), 2006/42/EG (from Dec. 29, 2009 on).
Dr. Egbert Schneider
Senior Vice President
2
Engineering
=5.0 m/s , Uncertainty
h
06.12.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Replacing the Sanding Sheet
(see figure A)
When attaching a new sanding sheet, remove any
dust or debris from the sanding plate 4, e. g., with a
brush.
The surface of the sanding plate 4 is fitted with Velcro
backing for quick and easy fastening of sanding
sheets with Velcro adhesion.
Press the sanding sheet 5 firmly against the bottom
side of the sanding plate 4.
To ensure optimum dust extraction, pay attention that
the punched holes in the sanding sheet match with
the holes in the sanding plate.
GEX 125-1 A
Professional
3 601 C87 0..
W 250
–
rpm 12000
opm 24000
mm 2.5
mm 125
kg 1.3
/II
Dr. Eckerhard Strötgen
Head of Product
Certification
Before any work on the machine itself, pull
the mains plug.
GEX 125-1 AE
Professional
3 601 C87 5..
250
7500–12000
15000–24000
2.5
125
1.3
/II
English | 15