Ce Declaration Of Conformity - Mesto 3585 Série Mode D'emploi

Faults
Use only spare parts and accessories from the manufacturer (you will find some in
the spare parts pouch [3], see insert).
Fault
No pressure builds up in
the device
Liquid flows out of the
pump.
Safety valves blows off
too early.
Pressure gauge is not
indicating any tank
pressure.
Contact address for additional information → see insert.
Warranty
We guarantee that from the time it is first purchased for a period of the legally valid required
warranty period (maximum 3 years) this device will not exhibit any material or processing
errors. If defects are discovered during the warranty period, the manufacturer or the
distributor in your country will repair the device without charging for the labor or material or
(at the discretion of the manufacturer) replace the device itself or its defective parts.
If such defects are discovered, please contact us immediately. We require the invoice or
cash register receipt for purchase of the device.
The warranty does not include wearing parts (seals, O-rings, diaphragm, etc.) or defects
which have occurred due to improper use or unforeseeable circumstances.

CE Declaration of Conformity

Products which belong to the 3585.. and 3615.. series satisfy the requirements of the
Pressure Equipment Directive 97/23/EC and carry the CE mark.
Cause
The pump is not screwed on
tightly.
O-ring [19] on the pump is
faulty.
Diaphragm [20] is defective.
Valve disk [21] dirty of
defective.
Safety valve [10] is defective.
Pressure gauge [14] defective. Sever attachments (at top, at
Remedy
Screw the pump on tightly
Replace the O-ring. (Fig. 16)
Replace the diaphragm.
(Fig. 16)
Clean or replace the valve disk.
(Fig. 15)
Replace safety valve. (Fig. 17)
bottom, on right) [22]. (Fig. 18)
Open panel [23], unscrew
pressure gauge [14] with
wrench and replace. (Fig. 18)
Insert fixing knob [24], push to
right and insert panel [23].
(Fig. 19)
13