EUROM WH2018 Manuel D'utilisation page 38

7. Press ; the display will show the start time. Press "TIME/OFF" to increase
the start time by one hour, e.g. to 13.00 (Fig. H). The stop time must always
be later than the start time. If both times are the same, the unit will switch to
standby.
8. Press the plus and minus buttons to set the required temperature.
9. While the display is flashing, you can change a setting or go to the next
setting. If you wait too long, the setting will be cancelled.
10. Finally, press OK to confirm the setting.
11. Repeat steps 3 to 8 to set a weekly programme of start and stop times, for 7
days and up to 6 programmes per day.
12. Follow the steps described above to change a setting. This will overwrite the
previous values. Confirm using the "OK" button.
13. To turn the weekly programme off, press "P" again. The "P" disappears from
the display and you leave the weekly programme. The unit returns to its
previous settings.
N.B.! The weekly programme is continuous, which means that it returns to day 1 at
the end of day 7. If that is not what you want, you should turn the weekly
programme off using the "P" button.
Comments:
To check the settings, press "DAY", "EDIT", "TIME/ON" then "TIME/OFF". The

display will show the settings.
The timer can only be set to hours, not minutes.

The "TIME/OFF" time must always be later than the "TIME/ON" time.

Your settings will be lost if the unit is switched off using the main switch, if

there has been a power cut or if the plug has been removed from the socket.
Press "SET" to check the day and time and set them again if necessary.
Set open window detector:
Make sure the unit is switched on and heating up.

Press ; the display shows the corresponding icon and the temperature (°C).

The standard temperature is 23 °C; you can change this using the plus and
minus buttons. When open window detection is switched on, the unit will switch
off if the temperature in the room drops by between 5 and 10 degrees within 10
minutes, and go to standby. In this case, you can turn the unit on again using
the on/off button.
Press the

disappears from the display and the unit returns to its previous settings.
If the heater is set to come on in a weekly programme and you turn the open

window detection on, this will only work while the unit is switched on in the
weekly programme.
button again to turn the open window detection off. The icon
38