Setting The Temperature; Selecting The Temperature Units; Using The Battery Monitor - Dometic Waeco Bordbar CDF-11 Notice D'emploi

_CDF-11.book Seite 25 Freitag, 24. September 2010 1:57 13
BordBar CDF-11
➤ Press the "ON/OFF" button (fig. 2 1, page 2) for three seconds.
✓ The "POWER" LED (fig. 2 2, page 2) lights up green.
When the cooler reaches the preset temperature, the LED lights up
orange.
✓ The display (fig. 2 5, page 2) switches on and shows the current cooling
temperature.
✓ The cooler starts cooling the interior.
5.7

Setting the temperature

➤ Press the "SET" button (fig. 2 4, page 2) once.
➤ Use the "+" (fig. 2 6, page 2) and "–" (fig. 2 7, page 2) buttons to select
the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The
display flashes several times and then the current temperature is dis-
played again.
5.8

Selecting the temperature units

You can switch the temperature display between Celsius and Fahrenheit.
This is how to do it:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 2 4, page 2) twice.
➤ Use the "+" (fig. 2 6, page 2) and "–" (fig. 2 7, page 2) buttons to select
Celsius or Fahrenheit.
✓ The selected temperature units then appear in the display for a few sec-
onds. The display flashes several times before it returns to the current
temperature.
5.9

Using the battery monitor

The device is equipped with a multi-level battery monitor that protects your
vehicle battery against excessive discharging when the device is connected
to the on-board 12/24 V supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set lev-
el. The cooler will switch back on once the battery has been recharged to the
restart voltage level.
Operation
25