Dometic Waeco Bordbar CDF-11 Notice D'emploi page 24

_CDF-11.book Seite 24 Freitag, 24. September 2010 1:57 13
Operation
5.5 Securing the cooler in the vehicle
➤ Open the lid of the cooler.
➤ Place the seat belt into the fixing position (fig. 1 3, page 2) of the cooler.
➤ Close the lid.
➤ Fasten the seat belt and tighten it.
5.6 Switching-on the cooler
Caution – Danger of overheating!
e
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
Warning – Danger of damaging the device!
e
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
The cooler can be operated with 12 V or 24 V
For safety reasons the cooler is equipped with an electronic system to pre-
vent polarity reversal. This protects the cooler against short-circuiting when
connecting to a battery.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate.
➤ Connect the 12/24 V connection cable to the cigarette lighter or an
12/24 V socket in your vehicle.
Caution!
a
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
Note
I
During normal operation the emergency switch (fig. 1 12, page 2)
has to be set to the "Normal" position.
24
BordBar CDF-11
.
g