Preparing For Use - Miele Complete C3 ACAA Boost Mode D'emploi

en

Preparing for use

Attach the suction hose (dia. 01)
 Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces.
To detach the suction hose (dia. 02)
 Press the release buttons at the side
of the hose connector, and lift the
hose from the socket.
Connect the suction hose to the
handle (dia. 03)
 Insert the suction hose into the
handle until it clicks into position.
Connect the handle to the suction
tube (dia. 04)
 Insert the handle into the suction tube
until it clicks into position. To do this,
line up the guides on the two pieces.
 To release the handle from the suc-
tion tube, press the release button
and pull the handle out of the suction
tube, twisting it slightly as you do so.
Adjusting the telescopic suction tube
(dia. 05)
One part of the telescopic tube is
packed inside the other, and it can be
adjusted to suit your height for comfort-
able vacuuming.
 Press the release button and adjust
the tube to the desired height.
38
Connect the telescopic tube to the
floorhead (dia. 06)
 Push the telescopic tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into posi-
tion.
 To detach the floorhead from the suc-
tion tube press the release button
and pull the suction tube away from
the floorhead, twisting it slightly as
you do so.
To adjust the floorhead (dia. 07)
This vacuum cleaner can be used for
daily cleaning of carpets, rugs and ro-
bust hard flooring.
Miele offer a range of other floorheads,
brushes and accessories for other types
of flooring and special requirements
(see "Optional accessories").
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
Vacuum carpets and rugs with the
brush retracted:
 Press the  foot control.
Clean hard flooring which is not sus-
ceptible to scratching, as well as floor-
ing with gaps or deep crevices in it with
the brush protruding:
 Press the  foot control.
If the suction power of the floorhead
seems too high, reduce the suction
until the floorhead is easier to man-
oeuvre (see "Use - To regulate the
suction power").