Installation - Favero Electronics FULL-ARM-01/T Mode D'emploi

ENGLISH
3. I
NSTALLATION
The power supply must be connected to the internal terminal block for the wall version FULL-ARM-01/W (Art.
825) or to the external connector for the table version FULL-ARM-01/T (Art.824). If this is carried out for
alternate current (12V ) it is not necessary to respect the polarity. For direct current (12V ) it is necessary to
AC DC
respect the polarity: if not the machine will not turn on.
Art.824 - FULL-ARM-01/T. Table version. The table version is supplied with a metal support equipped, at the
rear, with sockets for the connection of the weapons and for the power supply.
The version FULL-ARM-01/T (Art.824) is supplied with a feeding cable equipped with the connector.
Art.825 - FULL-ARM-01/W. Wall version. Unscrew the 7 screws at the back and remove the plastic back
panel. Carry out the connection of the weapons and of the power supply using the terminal block at the top
following the internal scheme (see Fig. 3.1). Replace the back panel making the cables pass through its
special slit at the bottom on the left. Rescrew the back screws. Connect the eventual LIGHTS REPEATERS
by inserting the telephone type connectors in the DATA-LINE sockets. Fix the FA01 on the wall using the two
frontal holes and the two screws you are supplied with.
Fig. 3.1: Internal connections for the Full-Arm-01/W, wall version.
Eventual fixing of the table support TABLE ADAPTER (Art. 826). Unscrew the back screws and remove the
plastic back panel. Disconnect the eventual connections to the terminal block. Insert the connector of the flat
cable coming out of the TABLE ADAPTER to the proper socket situated between the terminal block and the
DATA-LINE sockets. Replace the back panel making the flat cable pass through the lower side. Rest the
TABLE ADAPTER ontop and in the middle and fix it using the three long screws you are equipped with (one
superior screw and two lower screws). Rescrew the 4 remaining screws to the back panel.
For the connection of an external chronometer it is necessary to remove the plastic back panel and
connect the two wires of the contact of the chronometer to the terminal block, as indicated internally by the
writing CHRON. Moreover it is necessary to move the jumper, positioned near the terminal block, from the
position A to the position B.
To the DATA-LINE outlets placed behind, you can connect 2 LIGHTS REPEATERS (Art.894).
5 / 28
F E S 00824-M01-02-ML - Full-Arm-01 User Manual
AVERO LECTRONICS RL