Peaq PPA120BT-B Mode D'emploi page 27

English
4. Now set the volume using the + and
– buttons on the speaker's top (+ =
up, – = down) (fi g. 5). In addition, you
may increase the volume on the audio
source.
5. Turn off the speaker using the PAIR
button (fi g. 4). The LED goes off and
an acoustic signal sounds.
Notes:
• The speaker's maximum transmission range is about
10 metres. This range depends on diff erent factors (e.g. room
layout, wall material, audio source's transmission range).
• Make sure that the audio source supports the A2DP
standard.
Wired connection
1. Connect one of the included audio
cable's jack plugs to the AUX IN input
on the speaker's rear side (fi g. 6).
2. Connect the other end of the
audio cable to the audio source's
headphone socket.
3. Press the PAIR button on the top to
turn on the speaker (fi g. 4). The LED
on the right side ( white or red colour)
(fi g. 3) of the speaker's front lights up
steadily and an acoustic signal sounds.
28