Peaq PPA120BT-B Mode D'emploi page 26

27
Setting up Bluetooth connection
Attention! Make sure that before or during transmission via
Bluetooth no plug is connected to the AUX IN socket on the
speaker's rear side.
1. Press the PAIR button on the top
to turn on the speaker (fi g. 4). An
acoustic signal sounds.
2. The blue LED (fi g. 3) on the front
fl ashes and thus signalizes, that the
speaker is ready to be connected with
another Bluetooth device.
Note:
If no connection to another Bluetooth device is established within
5 minutes, the speaker will be turned off automatically.
1. Activate the Bluetooth function of the audio source (e.g.
smartphone, MP3 player, notebook, etc.). Browse for
devices and select "PPA120BT". If necessary, select the
speaker as audio output device. Refer to the audio source's
instructions.
2. After the connection is established, the blue LED (fi g. 3)
lights up steadily. An acoustic signal sounds simultaneously.
3. Firstly, set the audio source's volume to a low level and only
then start the audio playback. After only a few seconds the
speaker starts to emit the audio signal.
English